 | This
is the East Character I used on my Dance Dance Revolution pads. |
 | This
is the North Character I used on my Dance Dance Revolution pads. |
 | This
is the South Character I used on my Dance Dance Revolution
pads. |
 | This
is the West Character I used on my Dance Dance Revolution
pads. |
 | This is the pad
getting to where it actually looks like a ddr pad! Here I
have cut the 10 7/8" sq acrylic panels and I'm testing their
fit into the pad. The fit should be trimmed to fit in easily. If it's tight, your arrows will stick. You'll need two pieces of acrylic for each arrow. If you look carefully, you will see markings on the plexiglass. These mark where I will cut the plexiglass to make it octagonal. Which is covered in the next image. |
 | This
depicts an acrylic pane with a corner brace over it. The
black line across the corner is where the corner brace's edge matches
up on the plexiglass. The red line symbolizes where you should cut
the
plexiglass(or other acrylic). There should be an edge that sits
under the corner brace, but there should also be some space before
where the screws will be. |
 | This
is the corner of the acrylic panel after I marked it using the
method in the previous step. I will cut it on the line corresponding with the red line in the previous step. |
 | Here's
the acrylic with the corners cut. It is sitting in the space
for it, but I
don't have the switches or anything underneath it, so it's
sitting a bit low but otherwise a perfect fit. |
 | This
picture is showing that there is still an edge of acrylic that will
sit under the corner brace after it is cut. |